Learn more about setting the Multithreading preference to optimize performance. Multithreading: Multithreading affects how Logic distributes the DSP resources of your Mac.If you are using ReWire, set this option to Playback Mode. ReWire Behavior: If you aren't using ReWire, then set this option to Off.As with the I/O buffers, higher settings increase latency. Process Buffer Range: Set this option to Large.You can then set the I/O buffer size to 256 samples and leave it there for both recording and mixing. Choose Logic Pro > Preferences > Audio > General, and deselect Software Monitoring. If you're recording audio and not software instruments, you can monitor your audio directly from the source. The following suggestions may help prevent buffer overflow: Do not use the menus, click on the graphs, etc. To avoid latency and system overload alerts, decrease the I/O buffer size when recording, then increase it when mixing. The MP150 system is much faster and has more memory. Increasing the I/O buffer size reduces the load on the CPU of your Mac. However, larger I/O buffer sizes increase latency when recording. The I/O buffers temporarily store audio data before sending it to other destinations on your Mac. I/O Buffer Size: Increase the I/O buffer size, up to a maximum of 256 samples.You can use this information to make adjustments to your project or your system configuration.Ĭhoose Logic Pro > Preferences > Audio, click Devices, then adjust the following preferences: System overload alerts can appear when any of these meters peak. When a meter is full, the CPU or the disk has reached the limit of its processing capability. Watch the meters as the project plays back, noting when the meters are full. On Mac computers with processors that support Hyper-Threading, two meters are shown for each core.ĭisk I/O: Shows the amount of disk bandwidth used by Logic Pro. Each CPU core in your Mac has its own meter. The CPU/HD window has two sets of meters:Īudio: Shows the amount of CPU and RAM processing power used by Logic Pro. Double-click the CPU meter to open it in a new, expanded window. A CPU/HD meter appears on the right side of the LCD.Select the Load Meters (CPU/HD) checkbox, then click OK.
Choose Custom from the pop-up menu in the LCD section.Choose View > Customize Control Bar and Display.Choose any other additional options to streamline your workflow. Choose Logic Pro > Preferences > Advanced Tools, then select Show Advanced Tools.Use the meters in the Logic Pro CPU/HD window to monitor system performance while working on a project.
0 kommentar(er)
